Can a robot mower reach all your lawns?
By Fordham Tucker · Official US manuals checked November 16, 2026 · No hands-on mower testing
A mower that fits through a gate may still lack the room or conditions it needs to navigate. Survey the complete route from the charging station to each patch of grass before treating separate lawns as one automatic mowing job.
Use the model-specific manual checks, work through the gate example, then print the route survey for a seller or installer. This is a purchase-planning worksheet, not an installation approval.
Map the trip, not just the patch of grass
Label each grass area A, B and C. Draw the proposed charging position and a route to every area. Mark every gate, narrow section, turn, change of surface and step along each route. Keep grass area in the lawn-area worksheet; this sheet answers the separate question of access.
What the current US manuals actually say
The US Navimow download center links the manuals below, whose specification tables name the i210 AWD and X430. These are the ordinary connecting-channel instructions; they do not establish the installation requirements of a separate automatic gate accessory.
| Exact model | Body width / weight | Connecting channel | Unconnected lawn |
|---|---|---|---|
| Navimow i210 AWD (US) | 15.1 in wide 27.12 lb with battery | Must be wider than 1 m. | Isolated-zone tasks are one-time. Carry it to the lawn and back to the station for charging. |
| Navimow X430 (US) | 24.00 in wide 63.71 lb with battery | Must be wider than 1 m. | Isolated-zone tasks are one-time. Carry it to the lawn and back to the station for charging. |
| Mammotion LUBA 3 AWD 3000 | Not used to infer passage fit. | Current manual requirement remains unverified here. | Obtain the current model-specific transport, zone and charging instructions before planning the routine. |
Sources: US Navimow download center; i2 AWD manual 260109-A, printed pages 8, 17–18; X4 manual 260202-A, printed pages 7, 21–22. The Mammotion portal lists LUBA 3 V4.0, August 2026; its linked viewer did not provide extractable manual text in this research. We have not substituted another model or an older manual.
Wider than 1 m means more than 100 cm—approximately 39.37 inches. Exactly 100 cm does not satisfy that wording. This is a channel-width check, not a promise that a wider route will work. Body width alone cannot establish navigation clearance.
Measure the gate and the narrowest point after it
- Set the gate in the position it would occupy during mowing. Measure the actual clear opening, including hinges, latches, stops and anything projecting into the route. Record the unit. A nominal fence-panel or door size is not the clear width.
- Continue along the full route. Measure any tighter space between walls, edging, planting or equipment. Note how the mower would enter, turn, leave and return. Photograph the approach from both directions.
- Compare the narrowest usable section with the exact manual. If a requirement is unknown or a measurement is close to it, keep the route unresolved and request a site-specific answer. Do not round up to produce a pass.
Illustrative survey: the gate passes the width check; the route does not
A fictional opening measures 108 cm between fixed sides. A latch projects 4 cm into it, leaving 108 − 4 = 104 cm clear. Farther along, a wall and raised bed leave only 100 cm.
For the two Navimow manuals above, the gate exceeds the stated channel threshold, but the 100 cm section does not. The route remains unresolved. Even if every measured section exceeded 100 cm, turns, surface, positioning and boundary conditions would still need checking. These are example measurements, not observations from a tested yard.
Check the route, boundary and charging position separately
A width measurement cannot answer the following questions. Put each on the sketch so a seller or installer can assess the actual location:
- Surface and transitions: paving edges, roots, loose material, drainage, steps and abrupt level changes. Ask which transitions the exact model is permitted to cross; do not infer that from a general climbing claim.
- Slope: measure the route and any nearby edge separately. Record percent or degrees explicitly; use the slope-unit guide. A published maximum interior slope does not answer a gate-approach or boundary question.
- Navigation: record walls, overhangs, trees and the planned positioning setup. Get confirmation for both travel directions and the return to charging. A postcode coverage check alone does not survey a narrow passage.
- Barriers: mark roads, drops and water, and identify what a closed gate is intended to contain or exclude. Do not defeat a required barrier to create a mower route. Ask for the applicable installation guidance.
The i2 AWD manual calls for a soft, flat charging surface level with the lawn and an open area without signal blockages within 2 m. The X4 manual also specifies soft, flat ground level with the lawn, an unobstructed sky view, and positioning near the primary antenna when using Local RTK. Consult each model’s full placement diagram; these summaries are not interchangeable clearance plans. i2 AWD, printed page 13 · X4, printed page 16.
Choose a workable routine before choosing a mower
- A continuous route is proposed: complete the width, turn, surface, navigation, barrier and dock checks. Request confirmation of the exact configuration and a suitable demonstration. Keep unanswered items open.
- No usable route is confirmed: investigate the exact model’s separate-zone mode. Who would carry it, how often, by which route and how would it return to charge? Follow the manufacturer’s disabling and lifting instructions; never lift an operating mower. The stated weights above are worth considering before committing to a repeated task.
- Carrying is impractical or unsupported: compare maintaining that patch separately, changing the proposed scope, or obtaining a quote for another suitable arrangement. Do not count it as automatic coverage merely because the app supports multiple zones.
The next step may be a narrower mowing job, a seller visit or no purchase. Use the wire-free buying checklist for the broader ownership questions and the yard calculator for the separate area and slope screen.
Printable buying worksheet
Gate and separate-lawn survey
Complete one route sheet for each lawn. Write “unknown” when you lack a measurement or a current manual answer. No information entered on paper is sent to YardFit. Printing does not require an account.
Exact US model / variant / manual revision:
Lawn zone / grass area / proposed dock location:
Route from dock to zone (label on sketch):
Gate clear width / unit / opening position:
Narrowest route width / unit / location:
Latch, hinge, edging or other projections:
Turns, thresholds, steps, surfaces and drainage:
Route slope / edge slope / unit used:
Walls, trees, navigation setup and return path:
Water, road, drop or required barrier to review:
Dock placement / power / current manual answer:
If carried: model support / person / frequency / charging:
Unanswered questions / person responsible / reply date:
Next step: ☐ Request route confirmation ☐ Arrange a demonstration ☐ Plan a separate mowing routine ☐ Defer the purchase
Attach measurements, photographs from both directions and the relevant manual pages. A completed sheet is a record of questions and answers, not proof of fit or safety. YardFit · yardfitguide.com/gates-and-separated-lawns · November 16, 2026
Evidence and limits
We reviewed the official links above on November 16, 2026. The Navimow manuals identify the US models used in this comparison; firmware, accessories and installation instructions can change. The schematic, fictional width example and survey are YardFit planning aids. We have not measured a real gate, transported these mowers or tested navigation at a property.
Check the current manual for the exact product before buying. For corrections, contact hello@yardfitguide.com. See our research method and publisher, affiliate and privacy information. No active affiliate agreements or commission-earning links are used on this site.